Configuring Handhelds
This chapter provides information needed to:
• Maintain batteries used in the handheld.
• Change the default settings.
• Attach a wireless module when the handheld is used in the classroom.
Checking Battery Status
To check the status of the TI-Nspire™ Rechargeable Battery in a handheld:
1. Press c.
The Home screen opens.
2. Press 5 4 (Settings > Status).
The Handheld Status dialog box opens.
Battery status is shown here.
3. Click OK or press · to close the window.
Note: From an open document, press ~ 7 4 (~ > Settings & Status > Status).
Recharging the Handheld
To recharge the TI-Nspire™ Rechargeable Battery in a handheld, connect it to any of
the following power sources:
• A standard USB cable connected to a computer
• A TI USB wall charger (sold separately)
• A TI-Nspire™ CX Docking Station if in a classroom setting
Configuring Handhelds 71
To Next Page
Loading...
