INS877-4 18/26
Option 2
The Impaq S can also be wired with leaded resistors in an EOL configuration. The
alarm resistor should be connected across the alarm terminals, and the tamper
resistor should be connected from the right-hand alarm terminal to the left-hand
tamper terminal.
The zone wires should be connected to the outer alarm and tamper terminals.
Note: the EOL DIP switches should all be turned OFF in this configuration
Option 3
The third way of wiring an Impaq S is to use the EOL DIP switch selected resistors
for alarm and tamper.
In this configuration. The zone wires should then be connected to the outer alarm
and tamper terminals.
The EOL DIP switches should be set to the required zone EOL configuration.
To Next Page
Loading...
