Texi Tronic 1 User Manual

11
20. Feed dog tilting
To tilt the feed dog loosen screw B and turn screw A
in the correct direction.
Attention:
After this regulation feed dog height is changed, and
should be re-checked.
21. Needle bar and hook regulation
1. Turn pulley until the needle bar is located in its
lowest point and loosen screw (1).
2. Align marker line A on the needle bar with the
lower end of the needle bar sleeve (3) and
tighten screw (1).
3. Loosen the three hook screws, turn pulley and
level lower marker line B on the needle bar (2)
with the lower end of the needle bar sleeve.
4. After carrying out the above adjustment, level
the hook tip (5) with the center of the needle.
Set interval from 0.04 to 0.1 mm between the
needle and the hook and tighten hook screws
securely.
22. Foot bar height regulation
1. Loosen screw (1). Set the height and angle of
the presser foot.
2. After setting, tighten screw (1).
TEXI Tronic 1 operation manual

Texi Tronic 1 Specifications

General

Brand	Texi
Model	Tronic 1
Category	Sewing Machine
Language	English