Texi Tronic 1 User Manual

6
6. Fastening the needle
ATTENTION: Turn machine off before carrying out the below operations.
Select the needle appropriate to the sewn material.
1. Turn pulley until the needle bar reaches its
highest point.
2. Loosen screw (2) and hold the needle with
part A directed in direction B.
3. Insert needle into the needle holder, in the
direction of the arrow.
4. Check if the needle’s long groove C is
directed in direction D.
5. Tighten screw securely (2).
7. Insertion of bobbin into bobbin case
1. Insert the bobbin into the bobbin case so that
the thread winds to the left.
2. Lead the thread through the gap and pull it in
direction C. This way, the thread will pass
under the flat bobbin case spring B.
3. Check that the bobbin rotates in the direction
of the arrow, after it is pulled.
Set the bobbin on to the bobbin winder and
wind the thread onto it as shown on the figure.
TEXI Tronic 1 operation manual
8. Winding the bobbin

Texi Tronic 1 Specifications

General

Brand	Texi
Model	Tronic 1
Category	Sewing Machine
Language	English