BHT-206A/B-SERIES-MM-1
5-00-00
Page 70 Rev. 14 30 APR 2013
Export Classification C, ECCN EAR99
STARTER GENERATOR
Chapter 71 1. Remove starter generator. Examine mounting pad and
clamp for condition.
Chapter 96 2. Examine commutator for wear. Replace starter generator if
not smooth and bright or if showing excessive wear.
3. Inspect brushes for wear.
Chapter 71 4. Examine cooling duct and retention clamp for condition
and security.
5. Examine the splines on starter generator shaft and engine
gear shaft. If dry spline starter generator installed, clean splines
and lubricate.
DRIVETRAIN
Chapter 63 1. Examine freewheel assembly for condition leaks and
security.
Chapter 63 2. Examine the freewheel unit chip detector for accumulated
material.
Chapter 63 3. Examine forward short shaft (steel) disc pack couplings for
condition and security.
4. Examine forward short shaft (steel) splined adapters for
wear.
Chapter 12 5. Lubricate forward short shaft (steel) splined adapters.
Chapter 63 6. Torque check forward short shaft disc pack coupling
fasteners 50 to 70 inch-pounds (5.7 to 7.9 Nm).
Chapter 96 ELECTRICAL
1. Examine all electrical components, wires, cables, and
connectors in the power plant area for chafing, general
condition, and security.
5-23. 300-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 3 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
Need help?
General
