BHT-206A/B-SERIES-MM-1
5-00-00
30 APR 2013 Rev. 14 Page 153
Export Classification C, ECCN EAR99
5-50. 100 HOURS AFTER EACH INSTALLATION
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. _____________________
FACILITY: __________________________________________
HELICOPTER S/N: ___________________________________
REGISTRY NO.: _____________________________________
TOTAL TIME:_______________________________________
SIGNATURE:________________________________________
POWER PLANT
Chapter 71,
TB 206-13-204
1. Torque check engine mount attachment hardware at
engine and airframe attachment points.
2. If fastener is improperly torqued:
a. Check nuts tare torque, and bolt threads and shanks for
damage.
b. Check engine mounts and supporting structure for
damage.
c. Install new fastener if required, and apply torque.
Recheck torque at next 100 hours.
TAILBOOM
1. Torque check tailboom attachment nuts 360 to
390 inch-pounds (40.67 to 44.06 Nm).
TRANSMISSION
Chapter 63 1. Replace oil filter element and oil. Inspect removed element
for metal particles. If particles are found, investigate to
determine cause.
To Next Page
Loading...
Need help?
General
