BHT-206A/B-SERIES-MM-1
5-00-00
30 APR 2013 Rev. 14 Page 127
Export Classification C, ECCN EAR99
5-39. 1200 HOURS OF COMPONENT OPERATION
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH INITIAL
DATE: __________________W.O. _____________________
FACILITY: __________________________________________
HELICOPTER S/N: ___________________________________
REGISTRY NO.: _____________________________________
TOTAL TIME:_______________________________________
SIGNATURE:________________________________________
BHT-206B3-CR&O,
Chapter 62
MAIN ROTOR HUB ASSEMBLY
Applicable only to main rotor hub 206-011-100-127
and subsequent with yoke 206-011-149-105
installed.
1. Inspect yoke and trunnion bearing surfaces for brinelling.
2. Inspect yoke, latch bolts, strap pins, strap fittings, trunnion,
pillow blocks, grips, and pitch horns for corrosion.
3. Visually inspect all hub components for excessive wear or
damage.
BHT-206A/B-M&O TRANSMISSION (206-040-002-005, -013, AND -015)
Transmissions 206-040-002-005, -013, and -015 with
four pinion planetary (Post TB 206-75-12) and with
two main case electric chip detectors with cockpit
warning light connected and operational, do not
require this inspection. Refer to the 1500 hours of
component operation scheduled inspection
(paragraph 5-41).
To Next Page
Loading...
Need help?
General
