BHT-206A/B-SERIES-MM-1
5-00-00
Page 126 Rev. 14 30 APR 2013
Export Classification C, ECCN EAR99
(4) If wear is found in any one area in excess of
0.004 inch (0.01 mm) on any side, remove the assembly from
service.
Chapter 67 2. Install control tube, parts, and panels that were removed.
Chapter 63 MAIN DRIVESHAFT (206-040-015-ALL)
Chapter 12,
BHT-206B3-CR&O,
Chapter 63
Inspect inner and outer coupling teeth splines for wear and
corrosion, boot for condition, and shaft for damage and
corrosion. Inspection is to be accomplished concurrently with
lubrication requirements.
5-38. 600 HOURS OR 12 MONTHS OF COMPONENT OPERATION (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
Need help?
General
