BHT-206A/B-SERIES-MM-1
5-00-00
30 APR 2013 Rev. 14 Page 83
Export Classification C, ECCN EAR99
Chapter 96 ELECTRICAL
1. Verify operation of cockpit map reading light.
2. Verify operation of aft cabin reading lights, if installed.
USE EXTREME CARE WHEN IN PROXIMITY OF
PITOT TUBE WITH HEAT APPLIED. TOUCHING
TUBE MAY RESULT IN SERIOUS BURNS.
3. Verify operation of the pitot tube heating system.
4. Verify operation of defog blowers.
5. Verify operation of ENGINE OUT and LOW ROTOR RPM
audio and mute switch, if installed.
6. Verify illumination of all caution panel annunciator light
segments by depressing test switch, or each individual light
segment, as applicable.
7. Verify instrument lighting and dimming capabilities.
ZONE 8 — FORWARD FUSELAGE
PLACARDS AND MARKINGS
Chapter 11 1. Examine the placards, decals, and markings. Ensure they
are readable, correctly applied, and in agreement with the
applicable configuration of your helicopter.
FUSELAGE
Chapter 53 1. Examine forward fuselage for condition.
Chapter 52 2. Examine all cabin doors for condition and security. Give
special attention to the following:
a. Hinges
5-25. 300-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 5 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
Need help?
General
