BHT-206A/B-SERIES-MM-1
5-00-00
Page 90 Rev. 14 30 APR 2013
Export Classification C, ECCN EAR99
3. Examine electrical bonding strips for condition and security,
if installed.
4. Examine fairings for condition and security, if installed.
5. Examine crosstube riveted or clamped supports for
condition and security. Give particular attention to the sealant
joints around supports. Restore sealant (C-251) and paint finish
as required.
6. Examine crosstubes for corrosion and damage. Give
particular attention to areas where equipment is mounted.
Repair and/or restore surface protection as required.
7. Examine cabin entry steps for condition and security, if
installed.
8. Examine sealant joint at junction with skid tube saddles.
Restore sealant (C-251) and paint finish as required.
Chapter 32 SKID TUBES
1. Examine skid tubes for corrosion, damage, and security.
2. Examine skid shoes for condition and security.
3. Examine skid tube saddles for corrosion, damage, and
security.
4. Examine ground handling wheel attachment bolts for
condition and security.
GROUND RUN
GROUND RUN OF HELICOPTER TO BE
ACCOMPLISHED BY QUALIFIED PERSONNEL
ONLY.
Chapter 12 1. Make sure applicable servicing requirements have been
carried out.
5-26. 300-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 6 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
Need help?
General
