BHT-206A/B-SERIES-MM-1
5-00-00
30 APR 2013 Rev. 14 Page 103
Export Classification C, ECCN EAR99
5. Examine the bearings of the starter generator for smooth
rotation. Examine the splines on the starter generator driveshaft
and the mating splines on the engine gear shaft for wear. If dry
spline starter generator installed, clean splines and lubricate.
AFT FUSELAGE/TAILBOOM AREA
AFT FUSELAGE
1. Visually inspect longeron and engine pan interface for
corrosion as follows:
a. Open access door in overhead baggage compartment.
b. Open engine compartment cowling.
c. Using bright light and mirror, inspect exposed upper and
lower edges of the joints and fastener between aluminum
longeron and titanium engine pan. Edge of sealant coating
should be visible. No indications of corrosion are acceptable.
BHT-206-SRM-1 d. If there is no indication of corrosion and the bonded
surface seal is present, replace access panel and close engine
compartment cowling door. If corrosion is present or bonded
surface seal is not present, refer to the BHT-206-SRM-1 for
repair procedures.
e. Inspect engine mount attachment structures for cracks
and condition.
f. Remove fuel shutoff valve access panel. Inspect area
for corrosion, cracks, and fuel leaks. Check wiring and plumbing
for security and condition.
g. Inspect aft passenger rear bulkhead for indication of
screw contact or cracks in area of hat bin attachment anchor
nuts.
2. Inspect aft passenger rear bulkhead for distortion in area of
hat bin attachment anchor nuts.
5-29. 300-HOUR INSPECTION (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
Need help?
General
