BHT-206A/B-SERIES-MM-1
5-00-00
Page 34 Rev. 14 30 APR 2013
Export Classification C, ECCN EAR99
8. Examine external scavenge oil filter system (STC) (if
installed) for condition and security.
DRIVETRAIN
Chapter 65 1. Examine the oil cooler blower impeller for condition and
security.
2. Examine oil cooler blower impeller shaft for condition.
3. Examine oil cooler blower hanger bearings and brackets
for grease leakage and evidence of overheating.
4. Examine aft short shaft (aluminium) for condition and
security.
5. Examine aft short shaft (aluminium) splined adapter for
adequate lubrication and freedom of movement.
6. Torque check disc pack coupling fasteners 50 to
70 inch-pounds (5.7 to 7.9 Nm).
Chapter 96 ELECTRICAL
1. Examine all electrical components, wires, cables, and
connectors in the area of the aft deck for chafing, general
condition, and security.
GROUND RUN
GROUND RUN OF HELICOPTER TO BE
ACCOMPLISHED BY QUALIFIED PERSONNEL
ONLY.
Chapter 12 1. Make sure applicable servicing requirements have been
carried out.
2. Check oil level of transmission, hydraulic tank, engine, and
tail rotor gearbox prior to running helicopter.
5-17. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 2 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...