en-97
ADJUSTMENTS 9
9.12.6 ARMRESTS * **______________________________________________________
The armrests can be folded up if required and the height
individually adjusted.
To adjust the armrests for height, separate the round cap
(see arrow) from the cover, loosen the hexagon nut (size
13 mm) behind it and adjust the armrests to the desired
position (5-steps) and tighten the nut again.
Replace the cap onto the nut.
* If Fitted
** Optional Extra
9.12.7 ARMREST ADJUSTMENT * ____________________________________________
The inclination of the armrests can be modified by turning
the adjustment knob.
When turning the knob to the outside (+) the front part of
the armrest will be lifted, when turning the knob to inside
(-) it will be lowered.
* If Fitted
** Optional Extra
9.12.8 BACKREST ADJUSTMENT ___________________________________________
Moving the locking lever upwards loosens the notching of
the backrest adjustment.
After the adjustment, the locking lever must latch into the
desired position. It must not be possible to move the
backrest into another position when it is locked.
For an ergonomic use the backrest can be adjusted in a
range of –5 to +30 degrees (15 steps of 2.5 degrees
each).
To Next Page
Loading...
