Textron MPE 850 MARINE - 4.3.2 Checking coolant level

30 SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
3
2
1
5
4
6
4.3.2 Checking coolant level
4 Operation
4.3 Operating engine
Check the coolant level with a cold engine.
► Check the coolant level in the expansion
tank
1
.
The coolant level must be between the
MIN-marking
3
and the MAX-marking
2
.
NOTICE! Overheating damage caused by too low
coolant level.
► If coolant level is below the MIN-marking,
follow instructions in Refilling coolant
section.
NOTICE! Overfilled coolant increases the cooling
system pressure and may cause leaks in hoses.
► If coolant level exceeds the MAX-marking,
pump out excessive coolant using a suction
pump.
Refilling coolant
CAUTION! Scalding caused by hot steam. Open
expansion tank only with a cold engine.
► Unscrew the expansion tank cover
4
.
► Refill coolant, until the coolant level is
between the MIN-marking
6
and the
MAX-marking
5
.
► Close the expansion tank.
► Allow the engine to run at idle for
10 seconds.
► Check the coolant level.