31SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
4.3.3 Put the engine into operation
4 Operation
4.3 Operating engine
The following procedure is not a complete description of the commissioning, it describes only the engine-
specific requirements. Observe strictly the vehicle manufacturer's documentation.
NOTICE! Engine damage caused by overheating. If you operate the engine without sea water, the optimal
engine cooling is no longer provided. Observe chapter 5.2 Operating engine without sea water.
The vehicle is placed in the water.
► Put the throttle control in neutral position.
► Turn on ignition and press the starter button.
or
► Turn the ignition switch in the START position.
The engine will start.
► Warm up the engine. (See chapter 4.2 Operation during the break-in period.)
► Check the oil level. (See chapter 4.3.4 Checking oil level.)
To Next Page
Loading...
