Textron MPE 850 MARINE - Page 73

73SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
14
16
15
15
2
1
1
8 Service tasks in the workshop
8.8 Replacing rubber mount
► Close the hose clamp
14
.
Tightening torque:
3 Nm +0,5 Nm [2.2 lbf ft +0.4 lbf ft]
► Insert the hose
16
.
Observe the marking.
► Close the spring band clamps
15
.
► Touch up paintwork defects.
► Clear the service counter to reset service
light. (See the Textron Motors Diagnostic
Tool manual.)
► Update the engine control unit calibration.
(See the Textron Motors Diagnostic Tool
manual.)
► Turn on the ignition for about a minute, until
the throttle body opens and closes again.
► Test-drive the vehicle.
Engine model I2 846 MAR TC-155
Remove the rubber mount with a cold engine.
► Open the hose clamps
1
.
► Remove the connecting pipe
2
.