Textron MPE 850 MARINE - Page 75

75SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
11
9
10
13
12
12
8 Service tasks in the workshop
8.8 Replacing rubber mount
► Insert the hose clamp
10
and throttle body
9
.
► Close the hose clamp
11
.
Tightening torque:
3 Nm +0,5 Nm [2.2 lbf ft +0.4 lbf ft]
► Hold the the connecting pipe
13
in position.
► Close the hose clamps
12
.
Tightening torque:
3 Nm +0,5 Nm [2.2 lbf ft +0.4 lbf ft]
► Touch up paintwork defects.
► Clear the service counter to reset service
light. (See the Textron Motors Diagnostic
Tool manual.)
► Update the engine control unit calibration.
(See the Textron Motors Diagnostic Tool
manual.)
Turn on the ignition for about a minute, until
the throttle body opens and closes again.
► Test-drive the vehicle.