Textron MPE 850 MARINE - Page 82

82 SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
5
6
8
7
8 Service tasks in the workshop
8.10 Checking flame arrester
► Remove the flame arrester
5
.
► Clean the flame arrester with cleaning spray
according to the manufacturer's instructions.
► Attach the flame arrester.
► Close the hose clamp
6
.
Tightening torque:
4,5 Nm +1 Nm [3.3 lbf ft +0.7 lbf ft]
► Replace the clamp
8
.
► Insert the hose
7
.
► Close the hose clamp.
Tightening torque:
3 Nm +0,5 Nm [2.2 lbf ft +0.4 lbf ft]
► Touch up paintwork defects.
► Clear the service counter to reset service
light. (See the Textron Motors Diagnostic
Tool manual.)
► Update the engine control unit calibration.
(See the Textron Motors Diagnostic Tool
manual.)
► Test-drive the vehicle.