MANUAL P/N 900000165 REV H
3 Quick Setup Guide
3.1 Installation
Ensure the power, network and antenna connections have been provided as described in
section 2.
Connect the antenna to the BNC connector labelled antenna on the rear of the unit along with
power and a network connection. The network ports are supplied with default IP addresses of:
ETH1 192.168.101.10
ETH2 192.168.102.10
ETH3 192.168.103.10
3.2 Initial Configuration
The NTP80 is configured using a web browser. There are two options in order to access the web
configuration
a/ use the front panel to set an IP address to your local subnet. See section 6 on how to do this.
b/ use the default IP address of 192.168.101.10 on ETH1 with a PC or laptop that is configured
for this network subnet.
Then in either case the web configuration below can followed.
3.3 Main Configuration
The default username and password to access the web interface is
admin
ThePassword
3.3.1 Security
If you wish to change these settings then use the SYSTEM button on the right. Refer to section
5.1 on how to change the settings.
To Next Page
Loading...