MANUAL P/N 900000165 REV H
5.3 Configure, NTP Configuration
This page sets up the NTP service.
For the NTP80 with a GNSS receiver the GNSS checkbox must be ticked. The drop down list
selects the GNSS constellation used for resolving time. This is after position is resolved in which
all satellites in all constellations will be considered.
The constellation choices are: GPS, GPS+GLONASS, GPS+BEIDOU, GLONASS, BEIDOU.
The tracked satellites on status page will show the satellites used in each constellation.
STATS
This is used for diagnostic purposes and should normally NOT be enabled.
To Next Page
Loading...