MANUAL P/N 900000165 REV H
For GPS system state (applicable only to GPS NTP80plus) alarms caused by:
Time Not loaded NTP80plus GPS engine has not yet loaded time. Should only occur at
start-up of NTP80plus. After time has been set the alarm will clear. It can
then never be set again without power-down.
GPS Acquiring sync
GPS is not currently synchronised. The likelihood is that there are not
enough tracked satellites.
GPS Not present Should only occur and NTP80plus start-up.
For ETHx:
ifOperStatus down Network connection is not active. Check connectivity.
To Next Page
Loading...