Theben KNX Series User Manual

The application programmes RAMSES 718 P/S
RAMSES 718 P / RAMSES 718 S 23
Object 13: Operating mode preset or night <-> standby
The function of the object is defined by the parameter Objects for determining the operating
mode.
Objects for determining the operating
mode
Object function
new: operating mode, presence, window
status
Here, it is a 1 byte object. One of 4 operating modes
can be directly activated.
1 = Comfort
2 = Standby
3 = Night,
4 = Frost protection (heat protection)
The configured operating mode after reset is active
until a new valid operating mode is received or
changed at the device by the user.
old: comfort, night, frost
With this setting, the object is a 1 bit object. It can
be used to activate the operating mode Night or
Standby
0=Standby 1=Night
Object 14: Presence or comfort.
The function of the object is defined by the parameter Objects for determining the operating
mode.
Objects for determining the operating
mode
Object function
new: operating mode, presence, window
status
Presence:
The status of a presence detector (e.g. push button,
motion detector) can be received via this object.
1 on this object activates the comfort operating
mode.
old: comfort, night, frost
Comfort:
1 on this object activates the comfort operating
mode.
This operating mode takes priority over night and
standby modes.
Comfort mode is disabled again by sending a 0 to the
object.
 Nothing cyclical is to sent on this object as a
comfort extension (using button
7
on the
device) is cancelled if a 0 is received.
7
Only RAMSES 718 P

Theben KNX Series Specifications

General

Communication Protocol	KNX
Ambient Temperature	-5°C to +45°C
Storage Temperature	-25°C to +70°C
Protection Class	IP20
Relative Humidity	5% to 95%, non-condensing
Operating Voltage	24 V DC (via KNX bus)