Theben KNX Series User Manual

The application programmes RAMSES 718 P/S
RAMSES 718 P / RAMSES 718 S 56
4.7.1.1 Switch object parameter pages 1, 2, 3
Each of the 3 objects can be configured individually on its own parameter page.
Designation
Values
Description
Object type
Switching (1 bit)
Priority (2 bit)
Value 0-255
Percentage value (1 byte)
2 byte floating-point number
DPT 9.x
4 byte floating-point number
DPT 14.x
Telegram type for this object.
Send if
input = 1
no
yes
Send if voltage is present at the
input?
Telegram
With object type = switching 1
bit
ON
Send switch-on command
OFF
Send switch-off command
BY
Invert current state (ON-OFF-ON
etc.)
With object type = priority 2 bit
Function
Value
inactive
Priority not active
(no control)
0 (00bin)
ON
Priority ON
Priority ON (control:
enable, on)
3 (11bin)
OFF
Priority OFF
(control: disable, off)
2 (10
bin)
With object type = value 0-255
0-255
Any value between 0 and 255
can be sent.
With object type = percentage
value 1 byte
0-100%
Any percentage value between 0
and 100 % can be sent.
With object type = 2 byte
floating-point number
-670760…670760
Std.: 0
Any value between -670760 and
670760 can be sent.
With object type = 4 byte
floating-point number
-1E+38.. 1E+38
Std.: 0
Any value between -1E+38 and
1E+38 can be sent.
Input format: The ETS only allows
the input as a decimal without
power.
Example: 15234825.123456
Send if
input = 0
no
yes
Send if voltage is present at the
input?
Telegram
See above: Same object type as
Send if input = 1

Theben KNX Series Specifications

General

Communication Protocol	KNX
Ambient Temperature	-5°C to +45°C
Storage Temperature	-25°C to +70°C
Protection Class	IP20
Relative Humidity	5% to 95%, non-condensing
Operating Voltage	24 V DC (via KNX bus)