English 13
Maxitrol regulator conversion
• Remove conversion cap with a 7/8" socket or wrench.
• Snap-out stem from bottom of the cap, flip stem over to
show "LP" end, and snap stem back into the cap, as
shown.
• Re-install conversion cap -configured for LP gas- back
into top of the Maxitrol regulator.
Setting Manual Valve Screws for Cooktop / Rangetop
Screw driver for valve screw setting
A precision screwdriver with high-strength blade, similar to
the *Wiha no. 26033, with 1/8" [3.0mm] wide, .020"
[0.50mm] thickness tip, shown below, should be used to re-
position the bypass screws for minimum flow settings on
manual valves.
*Used by permission from Wiha Quality Tools division of Willi
Hahn Corporation USA.
Flip Stem
To Next Page
Loading...
