Need help?Do you have a question about the Thermal Dynamics Pak Master 100XL and is the answer not in the manual?
Explains how notes, cautions, and warnings highlight important information for safe operation.
Details critical safety measures for operating and maintaining plasma arc equipment.
Guides on choosing a suitable location for the power supply, considering ventilation and clearance.
Details the functions of the front panel controls and indicators for operating the unit.
Lists common operating issues and their potential causes and remedies.
Details input voltage, frequency, power, and current requirements for the power supply.
Provides recommended fuse sizes and wire gauges for safe electrical connections.
Explains how notes, cautions, and warnings highlight important information for safe operation.
Details critical safety measures for operating and maintaining plasma arc equipment.
Guides on choosing a suitable location for the power supply, considering ventilation and clearance.
Details the functions of the front panel controls and indicators for operating the unit.
Lists common operating issues and their potential causes and remedies.
Details input voltage, frequency, power, and current requirements for the power supply.
Provides recommended fuse sizes and wire gauges for safe electrical connections.
General| Input Frequency | 50/60 Hz |
|---|---|
| Output Current Range | 20-100 A |
| Open Circuit Voltage (OCV) | 300 VDC |
| Rated Output Current | 100 A |
| Duty Cycle | 60% @ 100 A |
| Input Voltage | 208/230/460 VAC |
| Input Phase | 1/3 |
| Cutting Capacity | 1.25 in (32 mm) |
| Severance Capacity | 1.5 in (38 mm) |
| Clean Cutting Capacity | 1 in (25 mm) |
| Gas Supply | Air or Nitrogen |
To Next Page
