EasyManuals Logo

Thermia ATEC Installation Guide

Thermia ATEC
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
8 SERVICE menu
8.1 Menu overview
N
To be able to chose a specific function, the sensor for that function must be connected.
HOT WATER
HEATING
COOLING
AUX. HEATER
MANUAL TEST
INSTALLATION
SYSTEM
HEAT SOURCE
POOL
DISTRIBUTION CIRCUIT 1-2
BUFFER TANK
OPTIMUM
CURRENT LIMITER
START UP CHECK
SERVICE TIME
FACTORY SET
RESET OPER. TIME
SENSOR CALIBRATION
VERSION
LOG TIME
DEFROST
OPTIMUM
BUFFER TANK
8.2
HOT WATER
Parameter Meaning
START Start temperature for hot water production. Shows the actual weighted hot water temperature and the value
within brackets indicates the start temperature. ( = no hot water production)
Factory setting: 40°C, range: , 30°C – 55°C
HOT WATER TIME Time for hot water production during combined hot water demand and heating or cooling demand, in minutes.
Factory setting: 20M, range: 5M – 40M
TOPH. INTERVAL Time interval between peak heating chargings (anti-legionella function) in days. Operating mode that permits
auxiliary heater must be selected.
Factory setting: 7D, (range: , 1D – 90D
TOPH. TIME Time in hours that the legionella demand is to be fulfilled for peak heating charging to be considered com-
plete.
Factory setting: , range: , 1H – 10H
TOPH. STOP Stop temperature for peak heat charging. Operating mode that permits auxiliary heater must be selected.
Factory setting: 60°C, range: 50°C – 65°C
INFL. H.W SENSOR. Hot water sensor’s influence compared with the peak sensor’s at start of water heating.
Factory setting: 65%, range: 0% – 100%
Installation Guide Atec
Thermia Värmepumpar VMBQY102
37

Table of Contents

Other manuals for Thermia ATEC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thermia ATEC and is the answer not in the manual?

Thermia ATEC Specifications

General IconGeneral
BrandThermia
ModelATEC
CategoryHeat Pump
LanguageEnglish

Related product manuals