7 Default setting in the control computer
The first column in the table below shows the parameters that can be
adjusted by the User. The second column shows settings made at the
factory, and the third column the settings made by the installation
contractor in connection with installation of the heat pump.
Setting Factory setting Any customer specific
settings
ROOM 20°C
OPERAT. AUTO
CURVE 40°C
MIN 10°C
MAX 55°C (45°C for under
floor heating)
CURVE 5 0°C
CURVE 0 0°C
CURVE -5 0°C
HEAT STOP 17°C
28 – User manual 086L0130 Rev. 1 EN
To Next Page
Loading...
Need help?
General
