When the heat pump is in position, remove the transport safety. (If the heat
pump should be moved further, put back the transport safety screw.) Make
sure all parts of the transport safety is removed!
The heat pump should be placed on a stable floor with a floor well (so any condensation may drain from the condensation hole in the
bottom of the heat pump), preferably a concrete floor. When placed on a wooden floor, the floor should be reinforced to hold the
weight of the heat pump, including a filled water heater. Consider that condensation water may drip from the drain hole, so take the
necessary steps to protect the floor.
Installation Guide Atlas & Calibra
BWCA01IG0202 Thermia AB
12
To Next Page
Loading...
Need help?
General