What to do if system backpressure is below 14 MPa in Thermo Scientific Dionex ICS-5000 Laboratory Equipment?
If the system backpressure is below 14 MPa, install a backpressure coil in the EG after the RFIC Eluent Degasser.
What to do if there's a flow system leak ahead of the cell in Thermo Scientific Dionex ICS-5000?
If you observe a flow system leak ahead of the cell, check all fittings and liquid lines for leaks. Tighten or replace all liquid line connections as necessary.
How to address low system backpressure due to a loose fitting in Thermo Scientific Laboratory Equipment?
To resolve low system backpressure caused by a loose fitting, ensure there are no liquid leaks in the flow system. Inspect tubing connections throughout the system, including check valves, injection valves, and columns, and tighten or replace fittings as needed.
What to do about high system backpressure due to restriction in Thermo Scientific Dionex ICS-5000?
If there is high system backpressure due to a restriction in the system plumbing, work backward through the system, starting at the flow cell exit. Loosen each fitting one at a time and observe the pressure.
What to do if Thermo Scientific Dionex ICS-5000 has insufficient system equilibration?
If the system has insufficient equilibration, especially after changes to operating parameters, allow a longer system equilibration time (up to 2 hours) before starting operation.
What to do if Thermo Scientific Dionex ICS-5000 Laboratory Equipment's TC temperature stabilizer is blocked?
If the TC temperature stabilizer is blocked, rinse the temperature stabilizer and the temperature stabilizer inlet line, using an appropriate solvent.
What to do if Thermo Scientific Dionex ICS-5000 Laboratory Equipment's RFIC Eluent Degasser tubing is ruptured?
If the RFIC Eluent Degasser tubing is ruptured, replace the degasser.
What to do if Thermo Scientific Dionex ICS-5000 has an internal EGC leak?
If there is an internal EGC leak, replace the EGC.
What to do for inadequate system backpressure in Thermo Scientific Dionex ICS-5000 Laboratory Equipment?
To address inadequate system or cell backpressure, add backpressure tubing to the cell outlet or to the pump (if no column is installed).
What to do if Thermo Scientific Laboratory Equipment DP/SP is not properly primed?
If the DP/SP is not properly primed, prime the pump.
General| Type | Ion Chromatography System |
|---|---|
| Data System | Chromeleon Chromatography Data System |
| Pressure Range | Up to 5000 psi |
| Power Requirements | 100-240 V, 50/60 Hz |
| Detector | Conductivity |
| Pump | Dual-Piston Pump |
| Column Temperature Range | 5°C to 80°C |
| Application | Environmental, Pharmaceutical |
| Flow Rate Range | 0.01 to 5.0 mL/min |
| Eluent Generation | Optional Eluent Generation Cartridge |
| Dimensions | Varies with configuration |
| Weight | Varies with configuration |
To Next Page