Need help?Do you have a question about the Thermo Scientific Dionex Integrion HPIC and is the answer not in the manual?
General| Minimum Flow Rate | 0.001 mL/min |
|---|---|
| Flow Rate Precision | <0.1% RSD |
| Column Heating | Yes |
| Pump Type | Dual-piston, serial pump |
| Detector Type | Conductivity Detector (CD), Electrochemical Detector (ED), UV-Vis Detector (VD) |
| Detection Methods | Conductivity, electrochemical, UV-Vis absorbance |
| Eluent Generation | Optional Reagent-Free™ Eluent Generation (RFIC) |
| Operating pH Range | 0-14 |
| Sample Capacity | Varies depending on autosampler configuration |
| Data Handling | Thermo Scientific Chromeleon Chromatography Data System (CDS) |
| Weight | Varies by configuration |
| Power Requirements | 100–240 V~, 50/60 Hz |
Step-by-step instructions for disassembling and rebuilding the high-pressure injection valve.
Guidance for rebuilding the auxiliary valve if it is installed and requires maintenance.
Procedure for removing and installing new pump check valve cartridges, including important notes.
Instructions for the removal and replacement of pump seals and associated components.
Steps to remove the old priming valve knob and install a new one.
Instructions for installing the new end-line filter into the eluent or deionized water line.
Final steps to ensure the system is operational after maintenance, including leak checks.
To Next Page