Thermon GENESIS User Manual

27
DTM DISTRIBUTED TEMPERATURE MODULE
The DTM is a DIN rail mountable six RTD sensor input
module which links the fi eld RTD wiring to the DCM
module via CANBus. Any RTD sensor may be mapped to
any heater circuit on the CANBus network.
DTM PRODUCT FEATURES
• Up to six RTD sensors that can be independently
addressed to one or more heat trace circuits
• DIN rail mountable
• Conformal coated printed circuit board for use in
panels located in indoor and outdoor environments
DTM COMPONENT SPECIFICATIONS
Storage ambient temp. range .-40°C (-40°F) to 105
o
C (221
o
F)
Operating ambient temp. range .........................................................
-40°C (-40°F) to 100°C (212°F)
1
Terminal connections.....................up to 2.5 mm
2
(28-12 Awg)
Maximum RTD capacity .........................................................................6
Weight ........................................................................... 123.32 g (4.35 oz.)
1. For designs that allow operation in ambient conditions below -40°F
(-40°C) contact Thermon..
DTM CONNECTION DIAGRAM
CANBus & Power
Connector
LED Identifi er To
Address Each DTM
And Each Of 6 RTD
Sensors
LED Identifi er To
Address Confi gurable
Input/Output
Channels
DTM DIMENSIONAL DATA
41 mm
(1-5/8")
111 mm
(4-3/8")
77 mm
(3")
IOM INPUT OUTPUT MODULE
The IOM is a DIN rail mountable input/output module
with 6 individually confi gurable input/output channels
and one dedicated system fault alarm output. Outputs
may be confi gured to signal a variety of conditions such
as trips, low temperature alarms, ground/earth leakage
alarms, etc. Inputs may be used to trigger a variety of
events such as load shed or forcing on circuits.
IOM DIMENSIONAL DATA
IOM PRODUCT FEATURES
• Operates in a wide range of ambient conditions
• DIN rail mountable
• Conformal coated printed circuit board for use in
panels located in indoor and outdoor environments
IOM COMPONENT SPECIFICATIONS
Storage ambient temp. range .-40°C (-40°F) to 105
o
C (221
o
F)
Operating ambient temp. range ..................................................................
-40°C (-40°F) to 100°C (212°F)
1
Terminal connections.....................up to 2.5 mm
2
(28-12 Awg)
Weight .............................................................................. 116.52 g (4.11 oz.)
IOM CONNECTION DIAGRAM
41 mm
(1-5/8")
111 mm
(4-3/8")
77 mm
(3")
CANBus & Power
Connector
Alarm Relay
Outputs
SPECIFICATION GUIDE
RTD Inputs
5THERMON.COM

Thermon GENESIS Specifications

General

Brand	Thermon
Model	GENESIS
Category	Controller
Language	English