6.OPERATION GUIDE
The Hunt series has been designed for long-term use. To ensure sustainable performance, please adhere to the following:
Hunt as an attachment is designed to use both in the nighttime and daytime under inclement weather (fog, smog, rain, etc.).
To mount it on a day scope, please follow the below instructions:
Before use make sure that you have mounted and adjusted the device according to the section “Operation Guide”.
Store with the lens cap on in the carrying case.
Switch off the device after use.
The device is designed for use in various operating temperatures. However, if it has been brought indoors from cold
temperatures, do not turn it on for 2 to 3 hours. This will prevent external optical surfaces from condensation.
To ensure reliable performance, it is recommended to carry out regular technical inspections of the device.
Please make sure that the day scope is zeroed before installation.
Measure the outer diameter of the lens of your day scope.
Select an appropriate adapter with the internal thread M52*0.75 and an insert of the required diameter depending on the
outer diameter of your day scope’s objective lens.
Install the insert into the adapter all the way in.
Install firmly the adapter with the insert onto the objective lens of your day scope.
Check that the adapter firmly fits the objective lens.
6.1 Installation
WARNINGS
Attempts to disassemble or repair the device will void the warranty!
15
To Next Page
Loading...
