EasyManua.ls Logo

Thevco VLC-3 - User Manual

Thevco VLC-3
36 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
VLC-3
Light Program Controller
USER'S MANUAL
6
7
,
5
)81&7,216
352*5$0
6(77,1*6
'
8
6
.
7
2
'
$
:
1
3
(
$
.
6
&
8
5
5
(
1
7
3
(
5
,
2
'
+5 0,1 
+50,1
0,16(&
M 890-00189 rev. 04 K 895-00406 rev. 00

Table of Contents

Questions and Answers

  • B
    Brittany PenningtonAug 11, 2025
    How to fix a Thevco VLC-3 Controller when the display doesn't work?
    • B
      barbara85Aug 11, 2025
      If the display of your Thevco Controller doesn't work, it might be due to several reasons. First, check if the circuit breaker at the service panel is off or tripped and reset it if necessary. Incorrect wiring could also be the cause, so ensure that the wiring is correct. Another potential issue is a blown F11 input fuse, which would require replacement. The voltage selector switch might be in the wrong position, so set it correctly. Lastly, confirm that the display board interconnect cable is firmly plugged into the power supply board.
  • M
    Mary PinedaAug 19, 2025
    What to do if Thevco Controller is working but the lights don't turn on?
    • J
      Julie KhanAug 19, 2025
      If your Thevco Controller appears to be working, but the lights aren't turning on, there are a couple of things you can check. Begin by examining the wiring to ensure it is correct and not loose. Also, verify the F1 output fuse; if it's blown, replace it.
  • K
    Kim ScottAug 26, 2025
    Why is the clock time flashing on my Thevco VLC-3 Controller?
    • A
      andersonchristinaAug 26, 2025
      If the clock time on your Thevco Controller is flashing, it could mean the clock has been reset, so try setting the clock. Alternatively, the battery might be defective. You can try turning the power to the unit off and then back on. If the clock time continues to flash after that, you should ask your dealer to replace the battery.
  • A
    Amy SteinSep 2, 2025
    What to do if Thevco VLC-3 Controller display flashes the letters "EEPR"?
    • K
      Kevin DixonSep 2, 2025
      If the display of your Thevco Controller flashes the letters "EEPR", it indicates that the memory chip may be defective. To attempt a fix, press and hold the push-button until the display clears, then release the push-button.

Thevco VLC-3 Specifications

General IconGeneral
BrandThevco
ModelVLC-3
CategoryController
LanguageEnglish