7
VLC-3 rev.04
VLC-3
When switch #1 is ON, the timer parameters are locked and can only be
displayed (except the clock time). When switch #2 is ON, the display
shows 24-hour time. Otherwise, the display shows 12 hour time (AM /
PM). Use switch #3 to select a curve (ON = fluorescent curve, OFF =
incandescent curve). The switch #4 determines the output operation
mode (ON = 1-10V, OFF = 0-10V). The switch #5 determines the
progression of lights intensity on manual mode. The switch #6 deter-
mines whether the sunset is performed before or after the Stop Time
(ON= before the stop time, OFF = after the stop time).
6. OVERVIEW
Notes:
(i) The minimum programmed intensity, sunrise duration and sunset
duration are common to all light programs.
(ii) Peaks are programmed separately for each period using a start time
and a duration and assume that the current intensity is at its maximum
programmed intensity. If this is not the case, the peak is not executed.
LIGHT
INTENSITY
TIME
100%
Maximum
Programmed
Intensity
Minimum
Programmed
Intensity
Dusk-to-Dawn
Start Time
Peak #1
Duration
Peak #2
Duration
Sunset
Duration
Peak #1
Start time
Peak #2
Start time
Sunrise
Duration
Dusk-to-Dawn
Stop Time
(If dipswitch
#6 = OFF)
Dusk-to-Dawn
Stop Time
(If dipswitch
#6 = ON)
To Next Page
Loading...