32
VLC-3 rev.04
VLC-3
Press the push-button.
The LAST DAY OF PERIOD pilot turns on and the last day flashes on
the display. Initially, the last day for period 2 is set to 365. Use the
adjustment knob to change the last day to its new value. The
program units defined previously for Period 2 are carried over to the
new period definition as shown below. At this point, no other
periods are defined. However, the program units defined for the
remaining periods are still in memory. As each new period is de-
fined, the program units stored in memory are assigned to it.
Press the push-button.
The PROGRAM NUMBER pilot light turns on and the display shows:
“dd . 1” where “1” (flashing) is the number of the dusk-to-dawn
program. Turn the adjustment knob until you reach the last light
peak for the current period (i.e. “PE . x” where x is the number of
light peaks for the period).
Press the push-button twice to advance to the next period.
The FIRST DAY OF PERIOD pilot turns on for the next period. Period
3 is defined to begin where Period 2 ends.
Press the push-button.
The LAST DAY OF PERIOD pilot light turns on and the last day
flashes on the display. Initially, the last day for period 3 is set to
365. Use the adjustment knob to change the last day to its new
value. The program units defined previously for Period 3 are carried
over to the new period definition, etc.
98199
365
Jour
Période 1
8 dd
12 PE
Période 2
4 dd
3 PE
To Next Page
Loading...