3. Use the [–]/[+] button to adjust the touch sensitivity in a range of 0 to 15.
4. Repeat steps 2 to 3 to adjust the touch sensitivity of the other pads as desired.
5. Press the [save] button to store the setting.
If you don't press any button on the drum module for 10 seconds, the unit automati‐
cally returns to the previous operating mode.
All unsaved changes are discarded when turning the drum module off.
When several pads are mounted on the same rack, vibrations may be transferred to other pads
and, thus, unwanted sounds are triggered when striking a pad. This crosstalk can be prevented
by the temporary suppression of the trigger signal.
1. Press the [voice/volume] and [song/volume] buttons simultaneously.
ð
The display shows the current signal suppression time in ‘Jxx’ format.
2. Press the button of the pad whose signal suppression time you want to change. Alterna‐
tively, you can directly activate the pad by playing it.
Crosstalk
Operation
e-drum module
30
To Next Page
Loading...
Need help?
General
