3. Adjust the signal suppression time using the [–]/[+] button in a range of 0 to 15.
4. Repeat steps 2 to 3 to adjust the signal suppression time of the other pads as desired.
5. Press the [save] button to store the setting.
The signal suppression time should be set as short as possible.
If you don't press any button on the drum module for 10 seconds, the unit automati‐
cally returns to the previous operating mode.
All unsaved changes are discarded when turning the drum module off.
You can adjust the pitch of each pad voice via the drum module.
1. Press the [voice/volume] button until the display shows the current pitch in ‘Pxx’ format.
2. Press the button of the pad whose pitch you want to shift. Alternatively, you can directly
activate the pad by playing it.
3. Shift the pitch using the [–]/[+] button in a range of 0 to 15.
4. Repeat steps 2 to 3 to adjust the pitch of the other pads as desired.
Pitch
Operation
MPS-200
31
To Next Page
Loading...
Need help?
General
