1. Hold down [KIT/VOICE] for about 2 seconds.
ð
The current Voice name and Voice number are displayed.
2. Strike the pad whose Voice you want to change.
ð
The name of the current pad is displayed.
3. Use the arrow buttons ([<] / [>]) or the jog wheel to select the desired voice.
The setting is automatically stored.
6.3 Playing the drum kit
Like on an acoustic drum kit, the pads respond to dierent playing techniques and
dynamics. All pads are velocity sensitive. Some voices change their timbre
depending on the punch used.
n Drums
With the snare drum we distinguish between Head and Rimshot.
– Head
Strike the head only.
– Rimshot
Simultaneously strike the head and the rim or only the rim of the pad.
n Cymbals
We distinguish the following cymbal zones:
– Bow
Play in the area between the edge and the bell of the cymbal.
– Choke
Choke Play is possible with Crash and Ride cymbals but not with the Hi-hat.
To do so, stop the sound of the Crash and Ride cymbals with the hand at the
edge of the cymbal immediately after hitting it.
n Hi-hat
With the Hi-hat we distinguish between Hi-hat pedal change, open Hi-Hat,
closed Hi-hat, Hi-hat pedal and Splash.
– Hi-hat pedal change
When the pedal is pressed in dierent positions, the voice changes when hit‐
ting the Hi-hat pad (similar to an acoustic drum kit).
– Open Hi-hat
Strike the Hi-hat pad without pressing the pedal.
– Closed Hi-hat
Strike the Hi-hat pad with fully pressed pedal.
– Hi-Hat pedal
Press the Hi-hat controller pedal to generate a closed sound without striking
the Hi-hat pad.
– Splash
Play the Hi-hat with fully pressed pedal and then open it suddenly.
Selecting Voices
Operating
MPS-450
15
To Next Page
Loading...
Need help?
General