Voice parameters always refer only to a single pad. For example, if you change the
volume of the snare drum, the other pads are not aected.
1. Hold down [KIT/VOICE] for about 2 seconds.
ð
The current Voice name and Voice number are displayed.
2. Strike the pad whose Voice you want to change.
ð
The name of the current pad is displayed.
3. Press [PAGE] repeatedly until the desired sub menu ‘VOICE NAME’ or ‘VOLUME’
is displayed.
4. Use the arrow buttons ([<] / [>]) or the jog wheel to change the parameter
value.
Param‐
eter
Display Meaning Value range
TRIGGER KIK, Sn, SnR, T1,
T2, T3, T4, HH, C1,
C2, Rd, Pd, PS
Trigger KICK, SNARE,
Snare Rim, Tom
1, Tom 2, Tom 3,
Tom 4, Hi-hat,
Crash 1, Crash 2,
Ride, Hi-hat
Pedal, Hi-hat
Splash
VOICE
NAME
NUM XXX Voice assigned to the trigger 1 … 408
VOLUME VOL XXX Volume 0…127
The existing preset kits can be used as a basis for user kits. The user kits can then be
stored in the device memory.
1. To save changes in the Drum Kit or Voice menu, press [SAVE/ENTER].
2. Use the arrow buttons ([<] / [>]) or the jog wheel to select a user kit in which
you want to save the changed settings (display shows 31 … 40).
ð
The User kit number ashes.
3. Press [SAVE/ENTER].
ð
The display shows ‘OK’ . The changes are saved.
6.5 Playing, customising and accompanying songs
Your digital drum module provides 80 preprogrammed songs. You can play the
songs and accompany them on the drum module. A song contains a drum part (con‐
taining the rhythm in which you play the pads) and an accompaniment part (percus‐
sion and melody). The volume of both parts can be adjusted separately.
Customising Voice parameters
Saving User kits
Selecting a song
Operating
MPS-450
17
To Next Page
Loading...
Need help?
General