17
LED display
Vacuum mode
Battery capacity (in %)
Sterilisation mode
Battery status
Clean water tank Cleaning roller
Self-cleaning mode
ECO mode Maximum power mode
Waste water tank
Cleaning modes:
Energy saving mode: Low suction power and low water supply.
Performance mode: High suction power and high water supply.
Vacuum mode: Suction only, no water supply.
Sterilisation mode: Electrolytic water is generated in the clean water tank for disinfection inside the appliance.
Note: Do not add any cleaning agent to the clean water tank in sterilisation mode. In sterilisation mode, you need to wait for 25-30 seconds until the water is
electrolysed before cleaning starts inside the appliance.
The indicator is flashing: the clean water tank is empty.
The indicator is flashing: the waste water tank is full, the suction channel is blocked or the waste water tank has not been inserted.
The indicator is flashing: the cleaning roller is not in place or is clogged.
Battery status display: blue after switch-on, green during the charging process. Flashes red when the battery charge level falls
below 15% or when the charging process is interrupted.
To Next Page
Loading...
