22
5. Cleaning the cleaning roller cover
It is recommended to regularly clean the cleaning roller cover after each use to
prevent dirt building up.
① Open the cover by pressing the two release buttons together with your thumb
and index finger.
② After removing the cover, rinse it with clean water and dry it.
③ Then replace the cleaning roller cover.
6. Cleaning the cleaning roller
It is recommended to clean and dry the cleaning roller thoroughly after each use.
Note: Place the appliance on the charging base and disconnect it from
the power supply.
① Open the cover over the cleaning roller by pressing the two release buttons
together with your thumb and index finger.
② Turn the cleaning roller release knob by 90° anticlockwise and then pull it
outwards to remove the cleaning roller.
③ Use the cleaning brush provided to remove hair or dirt from the suction
channel intake area.
④ There is a sharp blade in the handle of the cleaning brush provided that you
can use to cut hair and other dirt wrapped around the cleaning roller in order
to remove it.
⑤ Then wash the cleaning roller with clean water and leave it to air dry in the
accessory holder provided for this purpose on the charging base.
To Next Page
Loading...