THOMSON RR640CD - Nap Timer and Alarm; Setting Nap Duration

EN
Note:Note:
Note:Note:
Note:
When AC power is interrupted
and the unit is operating
through the DC backup
batteries, all wake mode will
work with buzzer instead.
10
Operating the Clock
Setting NAP Duration
You may take a short nap and be woken
up by the alarm.
1. Press NAP. The indicator and
0:20 (as default setting) will appear
on the display. (i.e. alarm will be
turned on in 20 minutes). Display will
switch back to real clock time after
about 3 seconds.
2. Press << REV or FWD >> to set nap
time.
Nap time decrease or increase
at 10 -minute intervals between 10
and 120 minutes.
3. Press NAP to activate countdown. The
display returns to the real clock time.
indicator lights continuously.
Alarm will sound once the timer
reaches 0:00.
4. Press and hold NAP until the
indicator disappears to cancel NAP
timer.
Tip:Tip:
Tip:Tip:
Tip:
To check the remain NAP timer,
press
NAPNAP
NAPNAP
NAP. The display will
show the minutes left. After 3
seconds, the display will return
to clock time.
Note:Note:
Note:Note:
Note:
Nap will not be activated again
the following day at the same
time.
Nap alarm is equipped with
GRAD-U-WAKEGRAD-U-WAKE
GRAD-U-WAKEGRAD-U-WAKE
GRAD-U-WAKE feature.
Turning NAP off
When nap alarm is activated, press OFF or
NAP to turn the alarm off.
Note:Note:
Note:Note:
Note:
The display backlight colour will
be in red when NAP is activated.