EN 7
Use system standby
System standby enables you to press the
button on,
for example, your TV remote control. This switches
your TV and all connected HDMI devices to standby
mode.
Press Menu on the remote control, then select
. Select On/off to enable
or disable the Network update function.
- When this function is on, the TV will automatically
update channels if your DTV service provider
updates his DTV network.
- When this function is off, you need to run the
channel search again to get new channels or
remove unavailable channels if your DTV service
provider adds or removes channels from their DTV
network.
Common interface
Encrypted digital TV channels can be decoded with a
common interface module and a card provided by a
digital TV service operator.
The common interface module may enable several
digital services, depending on the operator and
your digital TV service operator for more information
about services and terms.
Use the common interface module
common interface module may damage both the
Following the directions printed on the common
interface module, gently insert the module into the
common interface slot on the TV.
Push the module in as far as it will go.
Turn on the TV and wait for the common interface
function to be activated. This may take several
minutes.
N
ote: Do not remove the common interface module
from the slot. Removing the module will
deactivate the digital services.
After inserting and activating the common interface
module, press
Menu
on the remote control and select
Options > Common interface
.
This menu option is only available if the common
interface module is correctly inserted and activated.
On-screen applications and content are provided by
your digital TV service operator.
Press
Menu
on the remote control and select
. Press
OK
to enter.
- : Checks the current version of the
software.
- Product name: Displays the product name of your
set.
- Serial number
number of your set.
- OAD
latest version of the software if available. Select
OAD and press OK to enter.
lect Yes under
to automatically download the latest software if
available. After the software has been downloaded
successfully, you will be prompted to decide if you
want to install it right now. If yes, follow the on-
screen instructions to complete your installation.
You can also select to ignore the installation here.
Select No under to decline the
automatic download.
Select Manual OADand press OK
to start manual scanning the latest software.
Follow the on-screen instructions to complete.
During
the scan, press OK/Exit to cancel or exit
the process.
Change to Shop or Home mode
Press Menu on the remote control and select
.
Press to select your location Shop or Home.
Press Exit to exit.
Commission 2009/125/EC, in Home mode, TV
will be put into standby mode automatically if
there is no operation in 4 hours. This feature
can be deactivated in Options menu.
MHEG function
Some digital TV broadcasters offer dedicated digital
These services work like normal Teletext with the
addition of number, colour and navigation buttons.
Press
Menu
on the remote control and select
Options > Subtitle > Subtitle
.
Press
to set
Subtitle
to
Off
.
Note: MHEG and subtitles are mutually exclusive
and cannot coexist on the same screen. If
Subtitle is set to On, MHEG will not appear.
Press the red button or on the remote control.
Press OK
Press one of the colour buttons to select an option.
Press or Exit to exit.
Use more of your TV
To Next Page
Loading...
