EN 5
Note: Some options may not be available for
certain signal sources.
Select menu language
You can choose your preferred menu language
following the instructions below.
Press Menu to display the main menu.
Press to select Setup, then press OK
to enter.
Select and press OK to enter.
Select Menu language and press to select
your desired language to display the menus.
Press Exit to close the menu.
You can create four lists of your favourite TV channels.
Press
Press the yellow button to enter Channel list
selection. Press to select the favourite list
you want to set up your favourite channels. Then
press OK to enter the selected list.
Press the blue button to start editing your favourite
list. Press to scroll through the channel list
and press OK to select or deselect it.
Repeat this procedure to setup other favourite
channels.
Press to exit.
ECO dynamic backlight
Press Menu on the remote control and select
Picture > ECO dynamic back light.
Press to select desired power saving mode
to achieve the desired power saving effect. The
Picture preset option under Picture will now be
set to Personal simultaneously.
Press Exit to close the menu.
Shortcut operation: Press ECO on the remote
control to perform the same function mentioned above.
Motion enhance (* not available for some
models)
This function provides more sharpness to moving
pictures and launches the desired demonstration.
Press
Menu
on the remote control and select
.
Press
OK
to enter.
Select different options:
-
Effect
: Choose the high level to keep the picture
sharp at all times; however, very small details
may fade slightly at high speed. You can also
choose the low or middle levels to reduce the
motion compensation.
Use your TV & Use more of your TV
Chapter 3 & 4
way as in Initial setup. Select
Scan
and press
to start your automatic search relating to
all DVB-C digital and analogue channels.
- Select
Digital
, then follow the same process
as above to start your automatic search
relating to all DVB-C digital channels.
- Select
Analog
, then press
to start
your automatic search relating to all analogue
channels.
The search may take a few minutes. During the
process, you can press
Menu
to abort halfway.
Once the automatic search ends, press
Menu
to
return to the previous step or press
OK
to restart
your channel search.
After the automatic search, channels are arranged
in a preset order. You can skip channels, modify
the preset order or rename channels.
Access channels
Using the digit buttons: press the corresponding
digit buttons to access the channels.
Using the PR+/- or P+/- buttons: scroll through the
channels.
Repeatedly press Source on the remote control or
OK on the TV set to toggle between TV and other
input sources. To resume TV viewing, press any
digit button to enter the channel, while P+/- will cycle
through all TV channels and other input sources.
Note: Not all models have OK button on the set.
Volume control: use the or buttons
on the TV set or buttons on the remote control to
increase or decrease the volume.
Sound mute: press the
Mute
button to temporarily
mute the sound. Press this button again or the
button to restore it.
s
Press Menu to display the main menu. (Refer to
to select the desired item, then
press OK to open the corresponding submenu.
use to set functions or change values. Use
OK to activate a setting. Use to open the
corresponding submenu.
Press Menu to return to the previous menu.
Press Exit to close the menu.
To Next Page
Loading...
