EN 9
Assign a channel decoder
Decoders that decode analogue channels can
be connected to the AV connector. Assign the TV
channel as a channel to be decoded. Then assign the
connection where the decoder is connected.
Press Menu on the remote control and select
Setup > Decode.
Press to enter the list.
Press to select the channel to decode.
Press OK to select or unselect the channel.
Press Menu to return to the previous menu.
Press Menu on the remote control and select
Setup > Diagnostics.
Press OK
the current digital channel, such as signal strength,
frequency, etc.
Allows you to record the TV programme so that you will
not miss the favourite part even if you go out. Before
you use the function, connect a USB device to the TV
the USB device.
Press
Menu
on the remote control and select
.
On
to switch on the time shift
function, then press
Exit
to close the menu.
Press
Option
on the remote control and select
, then press
OK
Follow the directions on the screen to do the
setup.
After the disk setup is done, press
Option
and
select
.
Press
OK
to display the time shift menu.
- Press the red button to pause the picture and
begin the time shift.
- Press the red button to play the recorded part.
- When the time shift menu disappears and only the
timing of the time shift remains on the screen, you
can press the red button or
OK
to access the time
shift menu.
- Press the green button to fast backward or the
yellow button to fast forward.
- Press the blue button to quit the time shift
function.
Notes:
- Before you connect the USB device to the TV,
make sure you have backed up the data in the
device to avoid the loss of your important data due
to unforeseen malfunction.
- We recommend you use a USB device with free
capacity above 1GB and disk speed faster than
5.0MB/sec.
the recording time.
- If you change the channel in time shift mode, a
message prompts you to select
Yes
or
No
. You
can select
Yes
to exit the time shift function and
execute the channel change.
Reset shop
Allows you to reset the TV to factory default settings.
Press Menu on the remote control and select
Setup, then press OK
Select Reset shop and press OK
Use the digit buttons to enter the password.
OK and press OK
The Initial setup menu appears. Follow the
related instructions.
Customising the input settings
equipment you connect to it.
Press Menu on the remote control and select
Setup > Input settings.
Press to enter Input settings.
Press to select a connector your equipment
is connected to.
attached to this connector.
Press Menu to return to the Setup menu.
displayed after the name of the related connector in
the source list when pressing
Source
on the remote
control or
OK
on the TV set.
Note: Not all models have
OK
button on the set.
Use Electronic programme guide
EPG is an on-screen guide that displays scheduled
TV programmes. You can navigate, select, view and
record programmes.
Press
Guide
on the remote control, the
and Next EPG
menu will appear, which allows
you to get information about the current or next
programme playing on each channel. Navigate
through the different programmes using the
navigation buttons on the remote control.
Use the colour buttons to view the
8 Days EPG
.
-
-
Next day
-
this programme if available.
-
digital TV programmes.
Use more of your TV
To Next Page
Loading...
