Chapter 1: Connections and Setup
Illustrations contained in this document are for representation only.
15
Voice Over IP Cable Modem. The Installation Wizard serves as your step-by-step guide to
connecting and configuring your Voice Over IP Cable Modem.
1. Instructions must be followed in the order they appear.
1. Before you begin, close all open applications and dialog boxes as they may interfere with your
Voice Over IP Cable Modem installation.
2. Insert the supplied Voice Over IP Cable Modem CD-ROM. Wait momentarily for the CD window
display.
3. Close all open applications and dialog boxes, including the CD window.
Note: Open applications may interfere with your Voice Over IP Cable Modem installation.
4. Connect one end of the USB cable to the USB port located on the back of your computer.
Connect the other end of the USB cable to the USB port on the Voice Over IP Cable Modem.
Note: Use only the power supply that accompanied this unit. Using other power supplies may
damage the unit.
Next, you need to install the USB driver for your operating system.
Using Windows 2000 for USB Connection
Follow steps 6 through 14 if you have a Windows 2000 operating system:
5. When the “Found New Hardware Wizard” appears, click “Next” to initiate the search for drivers
for your USB device.
To Next Page
Loading...
