P18
MAIN MENU
After a few seconds, the receiver asks: “Are you sure to burn flash?”. Select Yes to finalize the
upgrade or No to quit without upgrading.
NOTE: If, after a software upgrade, the receiver should behave in an unexpected way,
please perform a factory reset as well. See chapter 7.4.2.
Warning: After an update the receiver restarts automatically. During the upgrade process
NEVER disconnect the receiver from the mains or switch off the power! Doing
so might damage your receiver and will void warranty!
7.4.5 Auto-update OTA
If set to On the unit will check automatically at the moment of going to stand-by for an Over The
Air software upgrade.
An Over The Air update might not be available in your region. Please visit our website
www.thomsonstb.net or contact your local service hotline for more information about this option.
7.5 Games
Your receiver is equipped with two games which can be played on your TV screen using the
receiver remote control.
Use pq to select Games from the Main menu and press OK or u to proceed.
Select one of the available games (Othello or Sudoku) using pq and press OK to start the game.
Follow the directions on screen. Press EXIT to quit a game.
7.6 Media
The Media menu consists of the following submenus: Media Player, HDD Information, DVR Setting
and Remove USB device safely.
Use pq to highlight the menu of choice and press OK to enter. Press EXIT to quit.
7.6.1 Media Player
This function allows playback of different kind of files from the connected USB storage device. In
the Media menu, select Media Player and press OK to enter this menu.
When entering the media player, the highlight is on the USB storage device. Press q and OK to
open the directory respectively its folders/subfolders.
First select which files you like to play back. Use the button 1 to switch between Video/Record/
Music or Image. Press pq to select a file or folder and then press OK to open the folder/
subfolder (if applicable) or start playback of the file. Press the EXIT button to exit.
Use the buttons like described below in order to choose functions during the different playback
modes (like described in the help banner below):