P22
TECHNICAL SPECIFICATIONS
Problem Possible cause What to do
Scrambled channel
Message
Channel is scrambled Select alternative channel
No response to remote
control
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Forgotten PIN code
Forgotten channel lock
code
Default PIN is 1234
Contact local Service
Hotline or send email
to our Support via
www.thomsonstb.net
After moving the receiver
to another room/area
you are no longer able to
receive digital reception
Antenna signals are too
weak
The signal strength/quality
might be less than before, if
using an indoor antenna.
Press the INFO button on
remote 3x to call up signal
bars and adjust antenna for
(maximum) reception
or rescan channels
When using an active
antenna, check antenna
power.
Try to use an outdoor
antenna.
The receiver switches off
automatically.
Auto Standby function
enabled.
Disable auto standby. See
section 7.3.7 for details.
Playback of video (or
Timeshift) is causing picture
freeze/macro blocks or
similar distortion, especially
on HD content.
Read/write speed of your
USB device could be
too low.
Make sure to use a USB
storage device with
sufficient speed and space.
Pen drives (‘USB sticks’)
may not support sufficient
speed.
9.0 TECHNICAL SPECIFICATIONS
Demodulator
Demodulator: COFDM; 16 QAM/64 QAM, QPSK
Transmission mode: 2 K - 8 K
Video Decoder
Profile level: MPEG-2 MP@ML, AVC/H264HP@L4.1, MPEG4 ASP supported
Video resolutions: 480i / 480p / 576i / 576p / 720p / 1080i / 1080p / By Native TV /
By source
Decoding & Video out: PAL
To Next Page
Loading...
