THOMSON TS 880 - Product Model Code Explained

TS 880 TRANSFER SWITCH
PM064 REV8 10/01/25 10 Thomson Technology
4.1. PRODUCT MODEL CODE
The type of TS 880 series transfer switch supplied is identified by way of a 21 digit product
code which appears on the equipment rating plate (MODEL) on the door of the transfer
switch, and on the transfer switch drawings. The model code structure and definitions are
as follows:
1 2 4 6 7 8 9 10 11 12 13 14 15 17 18 19 20 21
T S 8
1-3. SERIES 15 . VOLTAGE (CONTINUED) 18. UTILITY SWITCHING DEVICE (CONT'D)
TS - TRANSFER SWITCH
3
f
4 WIRE (GROUNDED NEUTRAL)
V - INSULATED CASE DRAW-OUT SWITCH
E - 120/208
1
C/W ELECTRONIC TRIP (800 - 4000A)
4 & 5. MODEL
F - 127/220 W - INSULATED CASE, DRAW-OUT SWITCH
88 - 880 SWITCH
G - 120240
1
(DELTA)
C/W ELECTRONIC & GF TRIP (800-4000A)
H - 220/380
2
X - SPECIAL
6. POLES
J - 240/416
2 - 2 POLE K - 254/440
19. GENERATOR SWITCHING DEVICE
3 - 3 POLE
M - 277/480
1
K - MOLDED CASE SWITCH (100 - 1200 A)
4 - 4 POLE
N - 347/600
1
M - MOLDED CASE SWITCH C/W THER-MAG
3
f
3 WIRE
TRIP (100-200A)
7. CONFIGURATION TYPE P - 208
N - MOLDED CASE SWITCH C/W ELECTRONIC
A - ATS Q - 220 TRIP (250-1200A)
B - BYPASS/ISOLATION ATS R - 240
P - MOLDED CASE SWITCH C/W ELECTRONIC
X - SPECIAL
S - 380
2
& GF TRIP (250-1200A)
U - 416 Q - INSULATED CASE, FIX MOUNT SWITCH
8 - 11. AMPERAGE
V - 480 (800A-4000A)
0100 W - 600 R - INSULATED CASE, FIX-MOUNT SWITCH
0150 X - SPECIAL C/W ELECTRONIC TRIP (800-4000A)
0200 T - INSULATED CASE, FIX-MOUNT SWITCH
0250
16. CONTROLLER
C/W ELECTRONIC & GF TRIP (800-4000A)
0400 2 - TSC800 U - INSULATED CASE DRAW-OUT SWITCH
0600 7 - NONE (MANUAL) (800 - 4000A)
0800 V - INSULATED CASE DRAW-OUT SWITCH
1000
17. ENCLOSURE TYPE
C/W ELECTRONIC TRIP (800 - 4000A)
1200 A - NEMA1, ASA #61 GREY W - INSULATED CASE, DRAW-OUT SWITCH
1600 B - NEMA2, ASA #61 GREY C/W ELECTRONIC & GF TRIP (800-4000A)
2000 C - NEMA12, ASA #61 GREY X - SPECIAL
2500 D - NEMA3R SD, ASA #61 GREY
3000
E - NEMA3R/4 DD, ASA #61 GREY
3
20. POWER CONNECTIONS
4000 F - NEMA3RX/4X DD A - STANDARD
(306 STAINLESS STEEL)
3
X - SPECIAL
12. APPLICATION
G - NONE (OPEN STYLE)
A - STANDARD H - NEMA 3RXDD (ALUMINUM)
21. ATS CONNECTION CONFIGURATION
5
B - SERVICE ENTRANCE
ASA#61 GREY
4
A - STANDARD
C - DUAL SOURCE X - SPECIAL B - ALTERNATE B (400-1200A)
X - SPECIAL C - ALTERNATE C (400-1200A)
18. UTILITY SWITCHING DEVICE
D - ALTERNATE D (400-1200A)
13. OPERATION TYPE
K - MOLDED CASE SWITCH (100 - 1200 A) E - ALTERNATE E (800-4000A)
1 - OPEN TRANSITION M - MOLDED CASE SWITCH C/W THER-MAG F - ALTERNATE F (800-4000A)
2 - MANUAL ELEC. OP. TRIP (100-200A) G - ALTERNATE G (800-4000A)
3 - CLOSED TRANSITION (MOMENTARY) N - MOLDED CASE SWITCH C/W ELECTRONIC X - SPECIAL
4 - CLOSED TRANSITION (SOFT LOAD) TRIP (250-1200A)
X - SPECIAL
P - MOLDED CASE SWITCH C/W ELECTRONIC
NOTES
& GF TRIP (250-1200A)
1
MULTI-VOLTAGE CAPABLE.
14 . SAFETY STANDARD
Q - INSULATED CASE, FIX MOUNT SWITCH
2
FOR 50 Hz APPLICATION.
A - UL 1008 (800A-4000A)
3
STANDARD ENCLOSURE RATING IS N3R
B - CSA C22.2 NO 178 R - INSULATED CASE, FIX-MOUNT SWITCH AT 800A AND ABOVE AND N4 AT 600A
X - NOT APPLICABLE C/W ELECTRONIC TRIP (800-4000A) AND BELOW.
T - INSULATED CASE, FIX-MOUNT SWITCH
4
ONLY AVAILABLE 800A AND ABOVE.
15 . VOLTAGE
C/W ELECTRONIC & GF TRIP (800-4000A)
5
FOR BYPASS SWITCH APPLICATIONS
1
f
3 WIRE
U - INSULATED CASE DRAW-OUT SWITCH REFER TO FACTORY
D - 120/240
(800 - 4000A)
5 16
8