INTERIOR
96
CUSTOMER CARE | 877.855.2867
11
Typical safety lock pin for cab bed lift
To lower the front cab powered drop down overhead bunk:
1. Turn the chassis engine OFF
2. Engage the PARKING BRAKE
3. Turn ON the master battery disconnect switch
4. Remove the travel locks (or pins)
5. Fully recline the driver’s and passenger’s seat backs
6. Some systems (if so equipped), require a secondary master power key be turned ON prior
to operation
7. Engage the operating switch to raise or lower the overhead bunk
To raise the front cab powered drop down overhead bunk:
1. Raise overhead bunk until it stops, then press and hold the control switch for 3 additional
seconds
2. Install the travel locks (or pins)
3. Lower the overhead bunk down onto travel locks (or pins), and press and hold the control
switch for another 3 seconds
e overhead bunk must be completely raised and secured in the travel position before
driving the motorhome. Always travel with the driver and passenger seats in the fully upright
(non-reclining) position.
Rear Garage Elevated Beds (if so equipped)
CAUTION
The rear garage elevated bed(s) must be stowed and properly secured in the up
position during travel.
Typical keyed bed lift safety switch
To Next Page
Loading...
